12
Cut flue exhaust tube (hot tube) to length
(Approximately flush with wall exit).
Connection plate will sit against wall.
Cut Air intake flue.
Ensure ends are burr free and round, test fit flue will
slide over connection.
Pull flue through approx. 100mm (will be pushed back
once terminal is fitted).
Feed power cable through wall and into wall terminal.
Feed power cable through wall and into wall terminal.
INSTALLATION INSTRUCTIONS (continued)
Apply an 8mm silicon bead fully around the inside of
the flue end (heater connection end)
Fit flue clamp over flue (loosely).
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com