21
INSTALLATION INSTRUCTIONS (continued)
Run flue from appliance to bottom entry on fan
module.
Support flue with brackets as required
Cut flue to length to suit connection.
Ensure ends are burr free and round, test fit flue will
fit over connection.
Apply an 8mm thick silicon bead fully around heater
connection approx. 10mm from the top.
Apply an 8mm silicon bead fully around the inside of
the flue end (heater connection end)
Fit flue clamp over flue (loosely).
Slide flue onto connection spigot fully.
Tighten clamp fully.
Wipe excess silicon, visually check connection to
ensure connection is fully sealed.
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com