Connecting a PC to the controller
NoteAction
Refer to the system documentation for your
PC, depending on the operative system
you are running.
Make sure that the network setting on the
PC to be connected is correct.
When connecting to the service port:
The PC must be set to "Obtain an
IP address automatically" or set as
described in Service PC Informa-
tion in the Boot Application on the
FlexPendant.
When connecting to the factory network
port:
The network settings for the PC de-
pend on the network configuration
setup by the network administrator.
1
Connect a network cable to the network
port of your PC.
2
connectb
A Service port on the controller
When connecting to the service port:
Connect the network cable to the
service port on the controller, or to
the service port on the computer
unit.
When connecting to the factory network
port:
Connect the network cable to the
factory network port on the com-
puter unit.
3
Operating manual - Getting started, IRC5 and RobotStudio 21
3HAC027097-001 Revision: P
© Copyright 2004-2018 ABB. All rights reserved.
1 Procedures
1.4 Connecting a PC to the controller
Continued
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com