1 GENERAL OVERVIEW
12
Table 1.1 (continued)
1 2
Phase transmission measurement accuracy1, if ½S11½ and
½S22½ of the DUT are less than –32 dB, and ½S21½ and
½S12½ values are as follows:
+5 dB to +15 dB
–50 dB to +5 dB
–70 dB to –50 dB
–90 dB to –70 dB
2o
1o
2o
6o
Magnitude reflection measurement accuracy1, if ½S11½ and
½S22½ values are as follows:
–15 dB to 0 dB
–25 dB to –15 dB
–35 dB to –25 dB
0.4 dB
1.0 dB
3.0 dB
Phase reflection measurement accuracy1, if ½S11½ and
½S22½ values are as follows:
–15 dB to 0 dB
–25 dB to –15 dB
–35 dB to –25 dB
3o
6o
20o
Receiver noise floor (IF bandwidth 10 Hz) –125 dBm
Trace noise (IF bandwidth 3 kHz) 0.001 dB rms
Uncorrected directivity 18 dB
Uncorrected source match –18 dB
Uncorrected load match –18 dB
AC mains voltage 100 to 240 VAC 50/60
Hz
Power consumption 40 W
Dimensions LxWxH 324x415x96 mm
1The specifications of the Analyzer apply over the temperature range of 23 °C ±5 °C (unless
otherwise specified) after 40 minutes of warming-up, with less than 1 °C deviation from the full two-port
calibration temperature, at output power of –5 dBm, and IF bandwidth 1 Hz.
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com