4 MEASUREMENT CONDITIONS SETTING
63
4.5.2 Sweep Span Setting
The sweep range should be set for linear and logarithmic frequency sweeps (Hz) and
for linear power sweep (dBm). The sweep range can be set as Start / Stop or Center /
Span values of the range.
To enter the start and stop values of the sweep range, use
the following softkeys:
Stimulus > Start | Stop
To enter center and span values of the sweep range, use
the following softkeys:
Stimulus > Center | Span
Note If the power sweep is activated, the values on the Start,
Stop, Center, and Span softkeys will be represented in
dBm.
4.5.3 Sweep Points Setting
The number of sweep points should be set for linear and logarithmic frequency sweeps,
and for linear power sweep.
To enter the number of sweep points, use the following
softkeys:
Stimulus > Points
4.5.4 Stimulus Power Setting
The stimulus power level should be set for linear and logarithmic frequency sweeps.
For the segment sweep type, the method of power level setting described in this section
can be used only if the same power level is set for all the segments of the sweep. For
setting of individual power level for each segment see section 4.5.8.
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com