4 MEASUREMENT CONDITIONS SETTING
64
To enter the power level value, use the following
softkeys:
Stimulus > Power > Power
4.5.5 Power Slope Feature
The power slope feature allows for compensation of power attenuation with the
frequency increase, in the fixture wire. The power slope can be set for linear,
logarithmic and segment frequency sweeps.
To enter the power slope value, use the following
softkeys:
Stimulus > Power > Slope (dB/GHz)
To enable/disable the power slope function, use the
following softkeys:
Stimulus > Power > Slope (On/Off)
4.5.6 CW Frequency Setting
CW frequency setting determines the source frequency for the linear power sweep.
To enter the CW frequency value, use the following
softkeys:
Stimulus > Power > CW Freq
4.5.7 RF Out Function
RF Out function allows temporary disabling of stimulus signal. While the stimulus is
disabled the measurements cannot be performed.
To disable/enable stimulus, use the following softkeys:
Stimulus > Power > RF Out
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com