4 MEASUREMENT CONDITIONS SETTING
72
R1 and R2 are the receivers of a reference signal, A and B are the receivers of a test
signal. A and R1 receivers are located in port 1, B and R2 receivers are located in port
2. There are six types of absolute measurements depending on the port number (See
table 4.10):
Table 4.10 Absolute measurements
Symbols Definition
A(1) Test signal receiver A (Source Port 1)
A(2) Test signal receiver A (Source Port 2)
B(1) Test signal receiver B (Source Port 1)
B(2) Test signal receiver B (Source Port 2)
R1(1) Reference signal receiver R1 (Source Port 1)
R2(2) Reference signal receiver R2 (Source Port 2)
4.7.4 Absolute Measurement Setting
To select absolute measurement, click softkeys:
Measurement > Absolute >
Receiver A, Source Port 1 |
Receiver B, Source Port 1 |
Receiver R1, Source Port 1 |
Receiver A, Source Port 2 |
Receiver B, Source Port 2 |
Receiver R2, Source Port 2
Note In absolute measurement mode, dBm measurement units
will be used for logarithmic magnitude format, W
measurement units will be used for measurements in linear
magnitude format. Other formats are not applied to absolute
measurements as power is measured in scalar values.
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com