Chapter 4: Site Requirements and Preparation SA-100 Planning, Installation and Administration Guide
ShoreTel 12.1 29
4.2.2 Back Panel
This section provides information about the SA-100 back pane. Figure 4-2 and Table 4-4
provide information about the SA-100 back panel.
Figure 4-2 SA-100 Rear Panel indicators and Connectors
Table 4-3 SA-100 Front Panel Indicators and Connectors
Item
Indicator, Button, or
Connector Description
1 Power-on indicator/
power button
The power-on indicator lights when the system power is
on.
The power button controls the internal power supply
output to the system. When the system bezel is installed,
the power button is not accessible.
2VGA Connector Not used.
3 Hard drive activity
indicator
Lights up when the hard drive is in use.
4 Diagnostic indicator
lights
The four diagnostic lights display error codes during
system startup. See “Diagnostic Lights” in the ShoreTel
Maintenance Guide.
5 System status indicator Lights blue during normal system operation. Lights amber
when the system needs attention due to a problem.
6 System identification
button
Activates indicator lights on the front and back panels that
facilitate locating the unit in the rack.
7 (2) USB Connectors Allows you to connects USB devices to the unit for system
recovery. The ports are USB 2.0-compliant.
8 Slide-out system
Identification panel
The top contains the ShoreTel product ID, part number
and serial number. The bottom contains two MAC
addresses for the two internal NICs.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com