Reference Material Understanding Configuration Parameters
5
ShoreTel IP Phone 930D Planning and Installation Guide 67
Ethernet1 Up to 10 ASCII
Characters
Status of the 1st Ethernet Interface.
Ethernet1 Status, Speed/Duplex
Where:
Status is 0 or 1 (disabled or enabled)
Speed/Duplex is one of the following:
Auto
10/FD
10/HD
100/FD
100/HD
CFG, MAN 1,Auto
FtpServers Up to 255 ASCII
Characters
A comma separated list of up to 2 FTP servers. If a
server is unavailable the base goes through the list until
a working server is found.
DHCP,
MAN
0.0.0.0
GatewayAddress Dotted Decimal ASCII Gateway address for the base. DHCP,
MAN
0.0.0.0
IcmpArpTimeout Up to 5 ASCII
Characters
Number of minutes before routing table entries created
by ICMP redirects are timed out of the routing table.
If 0, then they never time out.
CFG 0
Include Up to 64 ASCII
Characters
The file name that is specified shall be read and its
contents included into the master configuration file. Files
may be specified completely, or may include the
variables $Hardware, $Country or $Language. The
value of the Hardware Version (programmed into flash at
the factory e.g. K01M01P01L01), Country or Language
Parameter shall be substituted for $Hardware, $Country
or $Language when the file name is created. For
example:
Include "Country_$Country.txt" with the Country
parameter set to 3 would load in the file "Country_3.txt"
This will permit parameters to be specified based on the
Country and Language parameter values.
CFG “”
IPAddress Dotted Decimal ASCII IP address to be used by the base. DHCP,
MAN
0.0.0.0
KeepAlive Up to 3 ASCII
Characters
Number of seconds to wait for an audit endpoint
command before initiating the recovery procedures in
ShorelinePR.4.2.170. If set to zero recovery procedures
will never be started.
Valid range is 0 to 999 seconds.
CFG 120
Language Up to 3 ASCII
Characters
This parameter specifies the Language that is used by
the Include parameter to identify a particular file to
include. May be between 1 and 255.
SSON,
CFG, MAN
1
Layer2Audio 1 ASCII character Layer 2 audio priority values from 0 to 7. CFG,
LLDP
5
Layer2Tagging 1 ASCII character 802.1Q tagging enable on Port 1
0=Disable
1=Enable
SSON,
CFG,
MAN,
LLDP
0
Layer2Signaling 1 ASCII character Layer 2 signaling priority values from 0 to 7. CFG,
LLDP
0
LldpEnable 1 ASCII character LLDP enabled if 1 and disabled if 0. MAN 1
MaxJitter Up to 4 ASCII
characters
The maximum value that the jitter buffer may be allowed
to grow. Valid values are 40 to 140 mS in 1 mS steps.
CFG 50
Parameter Value Type Value Sources Default
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com