Chapter 14: Legacy Integration System Requirements
ShoreTel 8 Planning and Installation Guide 201
When using SMDI, ShoreTel voice mail configuration, the following features will not be
supported:
Office Anywhere
Setting call handling mode
Setting agent state
The following features will be supported:
Recording greeting and name
Setting TUI password
Enable/disable envelope information
Email voice message options
Find Me
Message functions including call back
Message sending functions
Workgroup
ShoreTel voice mail
Agents cannot be extensions in the legacy PBX
System configuration
Configuration parameters
14.11 System Requirements
The following are required on the ShoreTel 8 system, or on the legacy PBX to enable the
integration of the two systems:
ShoreTel 8 system
ShoreGear Voice Switch that supports a T1 circuit.
Legacy PBX
T1 or PRI card for the PBX
Available card slot and capacity for the added trunks
Required software or licenses to support the desired trunk interface
If PRI is used in the integration interface, the legacy PBX must emulate the CO or support
Network Side PRI.
14.12 Connection Cable
14.12.1Special Considerations - Nortel PBX
When integrating with a Nortel Meridian PBX, a T1 connection must be used since the
legacy system does not support Network Side PRI.
14.12.2Special Considerations - Avaya/Lucent PBX
Universal Dial Plan (UDP) Must be Active - This capability enables transparent dialing
between the Avaya/Lucent PBX and the ShoreTel 8 system. If this is not active, users on the
PBX will either have to dial a trunk access code to reach the users on the ShoreTel 8 system,
or configure forwarding from an extension in the legacy system to the ShoreTel 8 extension
using the trunk access code and the extension.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com