ShoreGear-220E1 Voice Switch Chapter G: ShoreGear Switches
328
G.8 ShoreGear-220E1 Voice Switch
The following sections describe ShoreGear-220E1 resource capacity, LED behavior, and
connectors. Figure G-8 displays the ShoreGear-220E1 front plate.
G.8.1 Switch Capacity
Digital Circuit Resources: 30 channels maximum
One E1 circuit, 30 channels per circuit
Make Me Conference Resource: none
Maximum IP Phone Resources: 220
Digital Channel Reallocation: 150
Built-in Resources: 70
G.8.2 LED Descriptions
G.8.2.1 Power LED
The ShoreGear-220E1 has one power LED, which indicates the following:
On: The switch is operating normally.
Off: The switch has no power.
Flashing
2 flashes—The switch failed its internal self-test. This indicates a hardware
failure; replace the unit and submit a Return Material Authorization (RMA) to
ShoreTel, Inc.
3 flashes—Booting via FTP. Flash memory might be corrupted. Go to the Quick
Look page to ensure that the system is running properly.
4 flashes—The IP address is unavailable. DHCP and BOOTP did not respond to
the IP address request, and the IP address is not available in nonvolatile
memory to continue boot process. The switch will automatically reboot in five
seconds and try again. Check the BOOTP/DHCP server and the network
configuration to ensure that the voice switch is receiving a valid IP address.
Figure G-8 ShoreGear-220E1 Front Plate
Default
Switch
Audio Output Port
(night bell)
Power
LED
Network
LEDs
LAN 2
Connector
RS-232C
Maintentance
Port
Status
LED
Audio Input Port
(music on hold)
Network
LEDs E1 LEDs
LAN 1
Connector
Monitor
Port
Tel co
Port
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com