Chapter G: ShoreGear Switches ShoreGear T1k Voice Switch
ShoreTel 8 Planning and Installation Guide 331
G.9 ShoreGear T1k Voice Switch
The following sections describe ShoreGear T1k resource capacity, LED behavior, and
connectors. The ShoreGear T1k is not supported in installations outside the U.S. and
Canada. Figure G-9 displays the ShoreGear T1k front plate.
G.9.1 Switch Capacity
Digital Circuit Resources: 24 channels maximum
One T1 circuit, 24 channels per circuit
Make Me Conference Resource: None
Maximum IP Phone Resources: None
G.9.2 LED Descriptions
G.9.2.1 Power LED
The ShoreGear T1k has one power LED, which indicates the following:
On: The switch is operating normally.
Off: The switch has no power.
Flashing
2 flashes—The switch failed its internal self-test. This indicates a hardware
failure; replace the unit and submit a Return Material Authorization (RMA) to
ShoreTel, Inc.
3 flashes—Booting via FTP. Flash memory might be corrupted. Go to the Quick
Look page to ensure that the system is running properly.
4 flashes—The IP address is unavailable. DHCP and BOOTP did not respond to
the IP address request, and the IP address is not available in nonvolatile
memory to continue boot process. The switch will automatically reboot in five
seconds and try again. Check the BOOTP/DHCP server and the network
configuration to ensure that the voice switch is receiving a valid IP address.
Figure G-9 ShoreGear T1k Front Plate
Default
Switch
Audio Output Port
(night bell)
Power
LED
Network
LEDs
LAN 2
Connector
RS-232C
Maintentance
Port
Status
LED
Audio Input Port
(music on hold)
Network
LEDs
LAN 1
Connector T1 LEDs
Monitor
Port
Telco
Port
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com