IPBX-24 Voice Switch Chapter G: ShoreGear Switches
354
supports options 66 and 67, set option 66 to the ShoreWare server’s IP address,
and set option 67 to /ts24/vxworks.
6 flashes—Using a previously stored IP address. A BOOTP/DHCP transaction
was attempted, but the BOOTP/DHCP server did not respond. The switch
continues to use the IP address stored in nonvolatile memory until it receives a
valid response. If the switch receives a response that provides a different IP
address, it reboots using the new IP address. If the switch receives a response
that matches the IP address stored in nonvolatile memory, it continues
operation, and the power LED stops flashing. If the problem persists, check the
BOOTP/DHCP server and network configuration.
G.15.1.2 Switch Port LEDs
The IPBX-24 has 24 telephone/trunk port LEDs. The color of the LED indicates the port
function:
Green when the port is a telephone port.
Yellow when the port is a trunk port.
Off indicates the port is reserved for IP phones, for conferencing, or is
unconfigured.
The following describes the switch port LED behavior and meaning:
Telephone Port LEDs (Green)
When on steady, the port is configured as a telephone port and the telephone is
idle.
When flashing with ring cadence, the telephone is ringing.
When flashing slowly, the telephone is off hook.
When flashing fast, the port is in use (call in progress).
Trunk Port LED (Yellow)
When on steady, the port is configured as a trunk port and the trunk is idle.
When flashing slowly, the trunk is off hook.
When flashing fast, the trunk is in use (call in progress).
Port LED (Red): When on, the port is out of service.
IP Phone (Off): When the LED is off, the port is reserved for IP phones, for
conferencing, or is unconfigured.
G.15.1.3 Network LEDs
The network LEDs indicate the speed at which the switch is communicating with the
network and whether there is network activity.
The network LED descriptions are as follows:
Link: When lit, the switch is connected to an Ethernet network.
100M
When lit, the switch is connected to a 100BaseT network.
When off, the switch is connected to a 10BaseT network.
Traffic: This LED indicates network activity, as follows:
When flashing, network activity is detected.
When on (not flashing), heavy network activity is detected.
When off, network activity is not detected.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com