416 Planning and Installation Guide ShoreTel 14
ShoreTel Voice Switches ShoreTel-220E1 Voice Switch
F
5 flashes — The operating system is not available. The switch is booting from FTP but cannot
find the boot files. It automatically reboots in five seconds. You can use BOOTP or DHCP to
tell the switch where the files are. If you are using BOOTP, set the BOOTP server to the IP
address of the ShoreTel server, and set the boot file to /tsk/vxworks. If you are using a
DHCP server that supports options 66 and 67, set option 66 to the ShoreTel server’s IP
address, and set option 67 to /tsk/vxworks.
6 flashes — Using a previously stored IP address. A BOOTP/DHCP transaction was
attempted, but the BOOTP/DHCP server did not respond. The switch continues to use the IP
address stored in nonvolatile memory until it receives a valid response. If the switch receives a
response that provides a different IP address, it reboots using the new IP address. If the
switch receives a response that matches the IP address stored in nonvolatile memory, it
continues operation, and the power LED stops flashing. If the problem persists, check the
BOOTP/DHCP server and network configuration.
Network LEDs
The ShoreTel-220E1 network LEDs (LAN1 and LAN2) indicate the speed at which the switch is
communicating with the network and whether there is network activity.
When both LAN connectors are connected into a redundant network configuration, one network port is
active while the other is in standby mode. If one LAN connection fails, the switch activates the other
port.
The network LED descriptions are as follows:
Link/Activity: When lit, this LED indicates that the switch is connected to an Ethernet network. This
LED indicates network activity, as follows:
When flashing, network activity is detected.
When on (not flashing), the switch is connected to an Ethernet network.
When off, the switch cannot detect an Ethernet network.
This LED is not directly related to any switch’s individual network activity. For example, if three
switches are connected to the same hub and one switch’s Traffic LED shows activity, the other
switches will indicate the same activity.
100M
When green, the switch is connected to a 100BaseT network.
When off, the switch is connected to a 10BaseT network.
Status LED
The ShoreTel-220E1 has one status LED to provide general information about the ports. The color and
blink pattern of the LED indicate the port function:
Status LED (Green)
When on steady, no ports are handling active calls.
When flashing fast, at least one port is handling an active call.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com