430 Planning and Installation Guide ShoreTel 14
ShoreTel Voice Switches ShoreTel 90BRIV Voice Switch
F
LED Descriptions
Power LED
The ShoreTel 90BRIV has one power LED, which indicates the following:
On: The switch is operating normally.
Off: The switch has no power.
Flashing
2 flashes — The switch failed its internal self-test. This indicates a hardware failure; replace
the unit and submit a Return Material Authorization (RMA) to ShoreTel, Inc.
3 flashes—Booting via FTP. Flash memory might be corrupted. Go to the Quick Look page to
ensure that the system is running properly.
4 flashes — The IP address is unavailable. DHCP and BOOTP did not respond to the IP
address request, and the IP address is not available in nonvolatile memory to continue boot
process. The switch will automatically reboot in five seconds and try again. Check the BOOTP/
DHCP server and the network configuration to ensure that the voice switch is receiving a valid
IP address.
5 flashes — The operating system is not available. The switch is booting from FTP but cannot
find the boot files. It automatically reboots in five seconds. You can use BOOTP or DHCP to
tell the switch where the files are. If you are using BOOTP, set the BOOTP server to the IP
address of the ShoreTel server, and set the boot file to /tsk/vxworks. If you are using a
DHCP server that supports options 66 and 67, set option 66 to the ShoreTel server’s IP
address, and set option 67 to /tsk/vxworks.
6 flashes — Using a previously stored IP address. A BOOTP/DHCP transaction was
attempted, but the BOOTP/DHCP server did not respond. The switch continues to use the IP
address stored in nonvolatile memory until it receives a valid response. If the switch receives a
response that provides a different IP address, it reboots using the new IP address. If the
switch receives a response that matches the IP address stored in nonvolatile memory, it
continues operation, and the power LED stops flashing. If the problem persists, check the
BOOTP/DHCP server and network configuration.
Network LEDs
The ShoreTel 90BRIV network LEDs (LAN1 and LAN2) indicate the speed at which the switch is
communicating with the network and whether there is network activity.
When both LAN connectors are connected into a redundant network configuration, one network port is
active while the other is in standby mode. If one LAN connection fails, the switch activates the other
port.
The network LED descriptions are as follows:
Link/Activity: When lit, this LED indicates that the switch is connected to an Ethernet network. This
LED indicates network activity, as follows:
When flashing, network activity is detected.
Terms of Use | Privacy Policy | DMCA Policy
2006-2022 Rsmanuals.com